FRU Replacement
QLogic 12800 Series
Management Module Replacement
FRU part number:12800-MM01
Removal Procedures
1.
Loosen the thumbscrew until it releases from the faceplate.
2.
Pull the release arms out until the management module disengages from the
backplane connector.
Figure D-8
3.
Carefully pull the module out of the chassis.
Replacement Procedures
1.
Slide the module straight into the open slot until it engages with the
backplane connector.
2.
Push the arm up until it locks in place.
3.
Tighten the thumbscrew.
4.
Make sure the module is operating and the Module Status, Chassis Status
and MRL Active LEDs are green.
D-10
12800 Management Module Removal
.
S
D000140-001 B