Qlogic 12000 Installation Manual page 18

Installation
12200/12300 Installation
• M6 screws
Installation
1. Install the hat rails with mounting ears towards the port side of the switch. Fasten
with three (3) #6-32 screws per rail. Torque screws to 8in-lb.
2. Install six (6) cage nuts into the rack posts. Two cage nuts into posts on the
front side of the rack and four cage nuts into posts in the rear of the rack. Note
that the front of the rack is where the switch is installed.
1-10
Figure 1-6 12200 Hat Rails
S
D000140-001 B