Seeb Module; Rj45 Leds; Mrl Active - Qlogic 12000 Installation Manual

A
• The switch silicon temperature is at a warning level (approximately 90 degrees
C).
• DC voltages on the board are slightly out of tolerance (12V Bulk, 5V, 3.3V
and 1.8V are all monitored).
• The module can no longer function properly. The system will take the
appropriate actions to ensure that no damage is done to its components.
• Blinking

SEEB Module

RJ45 LEDs

The RJ45 connectors have two LEDs, Act and 100. The 100 LED is
a 100Mbps link is connected. The Act LED is
been established, and blinking when the link is active.

MRL Active

The MRL Active LED is
is secured to the Serial, Ethernet, Chassis EEPROM Board (SEEB) and a
Management Module is installed in the front of the chassis.
D000140-001 B
Amber (once every four seconds) - LED test state.
Figure 1-51 SEEB Module LEDs
Green when the mechanical release latch (MRL) thumbsrew
Component LEDs
Amber when an Ethernet link has
Installation
Green when
1-63