Section 14 Simple Network Management Protocol Configuration; Managing The Snmp Service - Qlogic SANbox 9000 Series Interface Manual

Simple Network Management Protocol Configuration
This section describes the following tasks:
The Simple Network Management Protocol (SNMP) provides for the management
of the switch through third-party applications that use SNMP. Security consists of
a read community string and a write community string that serve as passwords
that control read and write access to the switch. These strings are set at the
factory to well-known defaults and should be changed if SNMP is to be enabled.
14.1

Managing the SNMP Service

You control the SNMP service SNMPEnabled parameters through the
Set Setup SNMP
SNMP Configuration" on page 14-4
59231-03 A
Managing the SNMP Service
Displaying SNMP Information
Modifying the SNMP Configuration
Resetting the SNMP Configuration
or Set Setup Services
Section 14
commands. Refer to
for more information.
"Modifying the
14-1