Replacing A Summitstack Or Summitstack-V80 Stacking Module - Extreme Networks Summit X150 Series Hardware Installation Manual

Replacing a SummitStack or SummitStack-V80
Stacking Module
The replacement process is the same for either a SummitStack or a SummitStack-V80 stacking module in
a Summit X460 series switch. You need the following tools to replace a stacking module:
ESD-preventive wrist strap
●
Screwdriver
●
To replace a stacking module:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2 Completely loosen the captive retaining screws and slide the installed stacking module out of the
switch (Figure 223).
Figure 223: Removing a SummitStack Module
3 Carefully slide the replacement module into the switch
4 Align and tighten the captive retaining screws.
Figure 224: Installing a SummitStack Module
Summit Family Switches Hardware Installation Guide
SH_218
(Figure 224).
SH_217
267