Summit X250E-48P Power Supplies; Internal Power Supply; External Power Supplies - Extreme Networks Summit X150 Series Hardware Installation Manual

Summit x150 series summit x250e series summit x350 series summit x450 series summit x450a series summit x450e series summit x460 series summit x480 series summit x650 series
Hide thumbs Also See for Summit X150 Series:
Table of Contents

Advertisement

Summit X250e-48p Power Supplies

The Summit X250e-48p switch is powered by both an internal power supply and an optional external
redundant power supply system.

Internal Power Supply

The Summit X250e-48p internal power supply can provide 370 W of PoE power, as follows:
In a 24-port configuration, it provides 15.4 W to each port.
In a 48-port configuration or any combination of ports where total PoE power does not exceed 370
watts, it provides 7.7 W to each port.
If the total system demands exceed this power limit, you can specify one of the following:
Port priorities to identify which ports should be ranked higher when allocating power
Port disconnect precedence to specify the method of shutting off ports when not enough PoE power
is available
NOTE
For a detailed discussion of these concepts, see the Power over Ethernet section in the ExtremeXOS
Concepts Guide.

External Power Supplies

The EPS-600LS External Power Module provides optional redundant power for the Summit X250e-48p
switch. Through the redundant power input connector on the rear panel, the switch can be powered by
one, two, or three external power modules installed in the EPS-C External Power Supply Chassis.
The PoE capability of the Summit X250e-48p varies depending on the number of external power
modules in use.
Table 8
the number of power supply modules in use.
Table 8: Number of External Power Modules and Corresponding PoE Behavior
Internal
Power
Supply
Status
EPS-600LS (1x)
Internal power
370 W of
supply:
redundant power
Power on
Internal power
370 W of
supply:
external power
Power Failure
only
For specifications and installation instructions for the external power module, see
Power Module" on page
Summit Family Switches Hardware Installation Guide
summarizes the PoE power behavior for the Summit X250e-48p switch based on
EPS-600LS (2x)
740 W of
external power only
Internal power supply
disabled
740 W of
external power only
96.
External
PSU/Chassis
Failed/Disconnecte
EPS-600LS (3x)
d
740 W of
370 W of
external power only
internal power only
with 2:1 redundancy
Internal power supply
disabled
740 W of
No PoE power
external power only
with 2:1 redundancy
"EPS-600LS External
39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents