Replacing A Fabric Module - Extreme Networks BlackDiamond X8 Series Hardware Installation Manual

Chapter 7: BlackDiamond X8 Maintenance Procedures

Replacing a Fabric Module

You need a the following tools to replace a fabric module:
ESD-preventive wrist strap
●
#2 Phillips screwdriver for the retaining screws on the fan tray
●
5/16-inch flat-tip screwdriver for the retaining screws on the fabric module
●
You can replace a fabric module without powering down the switch.
To replace a fabric module:
1 Attach the ESD-preventive wrist strap to your bare wrist. If it is not already connected, connect the
metal end to the receptacle at the right of the power input connectors.
2 Remove the fan tray in front of the faulty fabric module.
a Loosen the captive retaining screws at the top and bottom of the fan tray.
b Holding both handles, pull the fan tray straight out of the chassis.
c Set the fan tray aside in a safe place.
Figure 43: Removing a Fan Tray
78
BlackDiamond X8 Series Switches Hardware Installation Guide