Maintenance Procedures (Models Other than Summit X460, X480, and X650)
Removing an AC-Powered Summit Switch from a
Rack (Models Other than Summit X460, X480, and
X650 Series)
To remove an AC-powered Summit switch from a rack:
1 Remove power from the switch.
Unplug the power cables from the from the wall outlets first and then from the switch.
2 Disconnect the Summit switch from the redundant power supply (if applicable).
3 Loosen and remove the four screws holding the switch in place in the equipment rack.
4 Carefully remove the switch from the rack and place it on a secure, flat surface.
NOTE
For information about DC-powered units, see the next section,
from a
Rack."
For information about removing a Summit X460, series switch from a rack, see
For information about removing a Summit X480 series switch from a rack, see
For information about removing a Summit X650 series switch from a rack, see
Removing a Summit DC-Powered Switch from a Rack
This section describes how to remove the following Summit DC-powered switches from an
equipment rack:
Summit X250e-24tDC
●
Summit X250e-24xDC
●
Summit X250e-48tDC
●
Summit X450a-24tDC
●
Summit X450a-24xDC
●
Summit X450a-48tDC
●
You must adhere to specific safety requirements when you connect or disconnect a DC power source for
one of these Summit switches.
WARNING!
Be sure to disconnect all DC power cables before you disconnect the chassis ground wire.
252
"Removing a Summit DC-Powered Switch
Chapter
Chapter
Chapter
Summit Family Switches Hardware Installation Guide
10.
11.
12.