Connecting Stacking Cables; Connecting A Summitstack 40G Cable To A Stacking Port - Extreme Networks Summit X150 Series Hardware Installation Manual

Connecting Stacking Cables

To connect Summit switches in a SummitStack configuration, use the appropriate stacking cables for the
specific stacking ports on the switches. This section provides instructions to connect the following
stacking cables:
SummitStack 40G cable (see
●
SummitStack 128G cable (see
●
SummitStack 128G/20G cable (see
●
SummitStack 128G/64G cable (see
●
SummitStack 64G cable (see
●
SummitStack 64G/20G cable (see
●
QSFP+ direct-attach cable (see
●

Connecting a SummitStack 40G Cable to a Stacking Port

SummitStack 40G cables are used to connect 20-Gbps SummitStack ports on the following Summit
switches:
Summit X250e, X450, X450a, and X450e series switches with integrated SummitStack ports
●
Summit X480 series switches with installed VIM2-SummitStack modules
●
Summit X650 switches with installed VIM1-SummitStack modules
●
To connect a SummitStack 40G stacking cable:
1 Align the cable connector with the stacking port connector on the back of the first switch
(Figure 105).
2 Firmly press the cable connector into place on the mating stacking port connector.
3 Align and tighten the retaining screws on the cable connector.
Repeat steps 1 through 3
Figure 105: Connecting a Summit Stacking Cable
CAUTION
Avoid making sharp bends in the cable. Sharp bends can stress the cable and cause damage.
Summit Family Switches Hardware Installation Guide
page 151)
page 152)
page 154)
page 156)
page 158)
page 159)
page 161)
to connect the cable to the second switch.
ES4K037
151