Preparing The Cables; Installing The Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches

Preparing the Cables

A ring terminal and two spade terminals are provided with the PSU. You need a crimping tool to attach
the terminals to the power and ground cables.
To prepare the cables:
1 On each wire, strip 0.25 inch of insulation from one end.
2 Insert the stripped wire end all the way into the barrel of the terminal
terminal securely to the wire.
Be sure to attach the ring terminal to the green/yellow wire.
Figure 138: Attaching Terminals to Cables
Power connection wire

Installing the Power Supply

CAUTION
The handle on the Summit X460 DC PSU is not designed to be used to lift or carry the Summit X460
series switch.
To install a Summit X460 DC PSU:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 If necessary, remove a blank panel from the back of the Summit X460 series switch
Figure 139: Removing a Blank Panel
182
SH_109
SH_207
Summit Family Switches Hardware Installation Guide
(Figure 138) and crimp the
Ground wire
(Figure 139).
SH