Extreme Networks Summit X150 Series Hardware Installation Manual page 236

Installing Summit External Power Supplies
b Insert the provided screws and tighten them securely (see
Figure 196: Attaching the Mounting Bracket
c Repeat steps a and
4 Slide the EPS-C into a 19-inch rack and secure it using appropriate rack-mount screws.
5 Connect the keyed end of the redundant power cord to the EPS-C (see
side of the connector marked TOP is facing up.
The key is a plastic tab on the cable connector housing that fits into the EPS-C to ensure correct
alignment of the connector.
6 Connect the other end of the redundant power cord to the Summit X450e-48p or X250e-48p switch
(see Figure 197). Be sure that the side of the connector marked TOP is facing up.
Figure 197: Installing the Redundant Power Cord
Connect First
Redundant Power Output
! See Manual
236
EPS-C
Rack Mount Bracket
b for the other side of the EPS-C.
Figure 196).
C
S -
E P
EPS-C_01
Figure
EPS-C_03A
Summit Family Switches Hardware Installation Guide
197). Verify that the