Replacing A Summit X480 Fan Module - Extreme Networks Summit X150 Series Hardware Installation Manual

Maintenance Procedures for Summit X480 Series Switches

Replacing a Summit X480 Fan Module

The procedure for replacing a fan module is the same for either a Summit X480 series switch or a
Summit X650 series switch.
You need a 1/2-inch flat-blade screwdriver to replace a fan module in a Summit X480 series switch.
CAUTION
Be sure to finish the replacement procedure promptly. The switch may overheat if it is left without cooling
for an extended period.
To replace the fan module:
1 Completely loosen the captive retaining screws at the lower corners of the fan module
2 Slide the fan module out of the switch and set it aside.
Figure 235: Removing a Fan Module (Summit X650 Series Switch Shown)
3 Carefully slide the replacement fan module into the switch
Figure 236: Installing a Fan Module (Summit X650 Series Switch Shown)
4 Align and fully tighten the captive retaining screws.
280
SH_090
(Figure 236).
SH_091
Summit Family Switches Hardware Installation Guide
(Figure 235).