Installing The Replacement Psu - Extreme Networks Summit X150 Series Hardware Installation Manual

Figure 229: Removing a Summit X480 DC PSU
6 Carefully slide the PSU the rest of the way out of the switch.
7 If a replacement PSU will not be installed, install a cover over the unoccupied power supply bay.
NOTE
Unoccupied power supply bays must always be covered to maintain proper system ventilation and
EMI levels.

Installing the Replacement PSU

To install a replacement Summit X480 DC PSU:
1 Verify that the PSU is right side up (see
2 Carefully slide the PSU all the way into the power supply bay (see
the latch snaps into place.
CAUTION
Do not slam the PSU into the switch.
Figure 230: Installing a Summit X480 DC PSU
3 Reconnect the ground wire as described in the next section.
Summit Family Switches Hardware Installation Guide
SH_163
Figure 230)
SH_158
Figure 230). Push the PSU in until
275