Removing A Summit X650 Series Switch From A Two-Post Rack - Extreme Networks Summit X150 Series Hardware Installation Manual

Removing a Summit X650 Series Switch from a Two-Post Rack

Removing the Summit X650 switch from a rack requires two people to maneuver the switch and
disconnect the mounting hardware.
CAUTION
Make sure that proper ESD controls are in use before maintenance is performed. This includes but is not
limited to wrist straps that are grounded to the switch chassis and earth grounds.
To remove the Summit X650 series switch from a two-post rack:
1 Verify that the power supplies have been removed from the switch.
2 At the front of the equipment rack, support the switch while you remove the rack-mounting screws
holding the front mounting brackets in place against the rack post
Figure 259: Removing the Front Mounting Screws from a Two-Post Rack
3 Remove the screws holding the front mounting brackets to the sides of the switch, and set the
mounting brackets aside.
4 Support the front and back of the switch as you slide the switch back, off the rear mounting
brackets, and out of the rack
Set the switch on a secure work surface.
Summit Family Switches Hardware Installation Guide
(Figure 260).
(Figure 259).
SH_100
301