Safety Information; Installing A Summit Family Switch (Models Other Than Summit X460, X480, And X650 Series) - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches

Safety Information

Read the information in this chapter thoroughly before you attempt to install or remove a
Summit switch.
NOTE
See Appendix A, "Safety Information"
Specifications" for additional information regarding regulatory compliance certifications.
CAUTION
Be sure that proper ESD controls are in use before switch maintenance is performed. This includes but is
not limited to wrist straps that are grounded to the switch chassis and earth grounds.
WARNING!
Be sure to connect the chassis ground wire before you connect any DC power cables.
Be sure to disconnect the ground wire after you disconnect all DC power cables.
Installing a Summit Family Switch (Models Other than
Summit X460, X480, and X650 Series)
This section describes how to install the following Summit family switches:
Summit X150 series
●
Summit X250e series
●
Summit X350 series
●
Summit X450 series
●
Summit X450a series
●
Summit X450e series
●
For instructions to install the Summit X460 series switches, see
on page 172.
For instructions to install the Summit X480 series switches, see
on page 187.
For instructions to install the Summit X650 series switches, see
on page 203.
164
for additional safety information and
"Installing a Summit X460 Series Switch"
"Installing a Summit X480 Series Switch"
"Installing a Summit X650 Series Switch"
Summit Family Switches Hardware Installation Guide
Appendix B, "Technical