Selecting Power Supply Cords - Extreme Networks Summit X150 Series Hardware Installation Manual

Selecting Power Supply Cords

Extreme Networks does not include AC power input cords in the product box. To purchase a power
cord for your product and for your specific country, contact your local Extreme Networks Channel
Account Manager or Sales Manager, or purchase a cord from your local supplier.
To locate a Sales Manager or Partner in your region visit:
http://www.extremenetworks.com/how-to-buy/how-to-buy.aspx
The following are requirements for power cords used on AC-powered Summit family switches and
compatible external power supplies:
The power cord must be agency-certified for the country of use.
●
The power cord must have an IEC320-C13 connector for connection to the switch or external power
●
supply.
The power cord must have an appropriately rated and approved wall plug applicable to the country
●
of installation.
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
●
minimum wire size is 16 AWG (1.0 mm
WARNING!
When using multiple power supplies, make sure that each power supply is attached to an independent
circuit breaker. See the installation instructions for the power supply for proper sizing of the circuit breaker.
Make sure that the source outlet is properly grounded according to the country's local electrical requirements before
plugging the AC supply power cord into a power supply.
For specific product input power requirements refer to the data sheet of the product or modular power supply at
http://www.extremenetworks.com
NOTE
This equipment is not intended to be directly powered by power distribution systems where phase-phase
voltages exceed 240V AC (2P+PE), such as those used in Norway, France, and other countries. For these
applications it is recommended that a transformer be used to step down the voltage to < 240V AC from phase-
phase, or that you make a connection to a (P+N+PE) power distribution where voltages do not exceed 240V AC.
All installations should confirm that the product is reliably grounded according to the country's local electrical codes.
NOTE
Building codes vary worldwide; therefore, Extreme Networks strongly recommends that you consult
an electrical contractor to ensure proper equipment grounding and power distribution for your specific installation
and country.
Summit Family Switches Hardware Installation Guide
2
).
or to Appendix B of this guide.
2
) minimum; over 6 feet, the
311