Installing A Vim2 Module In A Summit X480 Series Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing a VIM2 Module in a Summit X480 Series
Switch
The installation procedure is the same for all VIM2 modules in the Summit X480 series switch. The
illustrations in this section show the VIM1-SummitStack module.
You need the following tools and materials to install a VIM2 module:
ESD-preventive wrist strap
●
#2 Phillips screwdriver
●
CAUTION
Summit VIM2 modules are not hot-swappable. Disconnect power to the switch before removing an installed
VIM2 module or installing a new VIM2 module.
To install a VIM2 module:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2 Disconnect the switch power.
3 Remove the cover plate from the VIM2 module slot:
a Remove the retaining screws at the top corners of the cover plate or module, and set the screws
aside in a safe place.
Save the retaining screws to secure the new module in the switch.
b Pull the cover plate away from the module slot
Figure 205: Removing a VIM Cover Plate
4 Remove the new VIM2-SummitStack module from its anti-static packaging.
Summit Family Switches Hardware Installation Guide
(Figure 205).
SH_150
245