Extreme Networks Summit X150 Series Hardware Installation Manual page 229

Figure 189: Connecting an EPS-500 Unit to a Switch
EPS-500
Extreme switch
3 Connect an appropriate AC input power cord to the AC connector on the EPS-500 unit.
NOTE
An AC power cord is not provided with the EPS-500 unit. See
page 311 for information about selecting a power cord.
CAUTION
The EPS-500 unit does not have a switch for turning the unit on and off. Disconnect power to the
EPS-500 unit by removing the plug from the electrical outlet. Be sure that this connection is easily
accessible to you.
4 Connect the other end of the AC power cord to the electrical outlet.
Be sure that the electrical outlet is properly grounded.
The Power LED on the front of the EPS-500 unit should light solid green to indicate that it is ready.
Summit Family Switches Hardware Installation Guide
Keyed end of
redundant power cord
To AC
Redundant
power cord
Slot for key
To AC
"Selecting Power Supply Cords" on
Collin's
ES4K021A
XM_074
229