Installing A Summit X480 Series Switch; Pre-Installation Requirements - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing a Summit X480 Series Switch

The Summit X480 series switch fits into a standard 19-inch equipment rack. The provided
rack-mounting brackets are adaptable to either two-post or four-post mounting.
The installation process includes the following tasks:
1 Install the switch in the rack.
2 (Optional) Install a VIM2 versatile interface module.
3 Install one or two power supplies and connect power cables.
4 Connect network interface cables.
If you are installing Summit X480 series switches for use in a SummitStack configuration, read
Chapter 5 before you install the switches.
NOTE
Take care to load the rack so that it is not top-heavy. Start installing equipment at the bottom and work up.

Pre-installation Requirements

Installing the Summit X480 switch requires two people to maneuver the switch and attach mounting
hardware.
To allow safe handling of the switch during the installation process, make sure you have the following
available space around the rack:
Back: Minimum 30 inches behind the rack posts.
●
Sides: For a two-post rack installation, allow adequate space for access to the sides of the switch so
●
that the front mounting brackets can be attached to the switch.
The following items are provided with the Summit X480 series switch:
2 front mounting brackets
●
16 screws for attaching the front mounting brackets to the switch enclosure
●
2 pairs of rear mounting brackets, one shorter and one longer
●
You need the following additional tools and materials:
Four rack mounting screws
●
The screw size will vary based on your organization's rack system; screws are not provided.
Screwdriver for securing the switch to your organization's rack
●
The screwdriver size will vary based on the requirements of your organization's rack system.
AC power cord for each installed AC power supply
●
An AC power cord is not included with the Summit X460 series switch. You must obtain a power
supply cord that meets the requirements listed under
ESD-preventive wrist strap for installing optional ports at the back of the switch
●
Summit Family Switches Hardware Installation Guide
"Selecting Power Supply Cords" on page 311.
187