Installing A Summit X460 750 W Ac Psu - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches

Installing a Summit X460 750 W AC PSU

WARNING!
To prevent an electrical hazard, make sure that the AC power cord is not connected to the PSU before you
install the PSU in the power supply bay.
CAUTION
Make sure that the AC PSU circuit is not overloaded. Use proper over-current protection, such as a
circuit-breaker, to prevent over-current conditions.
To install a Summit X460 750 W AC PSU:
1 If necessary, remove a blank panel from the back of the Summit X480 series switch
Figure 133: Removing a Blank Panel
2 Verify that the PSU is right side up (see
3 Carefully slide the PSU all the way into the power supply bay (see
the latch snaps into place.
CAUTION
Do not slam the PSU into the switch.
178
SH_204
Figure 134).
Summit Family Switches Hardware Installation Guide
(Figure
Figure 134). Push the PSU in until
133).