Table of Contents
Advertisement
Setting menus
About passwords
A password is required to configure the interface card. When you
click OK in the setting dialog box or click the Return to default
button, the Password dialog box appears.
1. To set a password or to change the current password, click
Change.
2. In the Administrator password dialog box, enter a password
(up to 20 characters) and click OK. Passwords are case
sensitive.
Note:
The same password is used for EpsonNet WinAssist,
MacAssist, and WebAssist.
Since the new password becomes effective after sending the data
to the interface card, enter the old password immediately after
changing the password.
If you forget your password, you need to initialize the interface
card. See "Initializing the Interface Card" on page 1-6 for
instructions.
The EpsonNet Configuration Utility
10
10-7
Advertisement
Table of Contents
