Table of Contents
Advertisement
Setting menus
About passwords
A password is required to configure the interface card. When you
click OK in the setting dialog box or click the Return to default
button, the Password dialog box appears.
1. To set a password or to change the current password, click
Change.
2. In the Administrator password dialog box, enter a password
(up to 20 characters) and click OK. Passwords are case
sensitive.
Note:
The same password is used for the EpsonNet WinAssist,
MacAssist, and WebAssist.
Since a new password will not be effective until after the data
is sent to the interface card, enter the old password immediately
after changing the password.
If you forget your password, reset the interface card to the
default settings. See "Initializing the Interface Card" on page
1-8 to initialize the interface card.
The password you set here with EpsonNet WinAssist is not
available for interface card models C82362 , C82363 , and
C82364 with software version 1.x.
The EpsonNet Configuration Utility
9
9-7
Advertisement
Table of Contents
