Epson EpsonNet C82391 Series Administrator's Manual page 269

Unable to make settings using EpsonNet WebAssist.
Cause
You haven't set the IP
address for the interface
card.
Unable to set the IP address using the arp/ping commands.
Cause
The network cable may be
disconnected.
The address of the router is
set as the default gateway.
The Printer Model and IP Address do not appear in the
EpsonNet WinAssist dialog box.
Cause
If the IP address is set to the
default IP address, the items
above might not appear.
What to do
Set the IP address for the interface card
using EpsonNet WinAssist, MacAssist,
or the ping command, as described in
Chapter 2. You can check the IP address
on a status sheet.
What to do
Connect the network cable. Also, check
the network environment.
Set the IP address of your computer for
the default gateway temporarily. After
setting the IP address, return the IP
address to the original value.
What to do
Set a valid IP address.
Refresh the status. To do this, select
Refresh from the View menu.
Increase the length of time before a
time-out. To do this, select Timeout
from the Tool menu. Please note that
doing so can cause EpsonNet
WinAssist to run more slowly.
Troubleshooting
15
15-3