Table of Contents
Advertisement
Setting the IP Address Using EpsonNet WinAssist/
MacAssist
This section explains how to set the IP address for the interface
card using EpsonNet WinAssist or MacAssist.
Note:
Be sure that the TCP/IP protocols are installed on your computer.
See "Installing TCP/IP Protocols on Your PC" on page A-1 for
instructions.
The interface card is set to the default IP address "192.168.192.168".
This private IP address may cause conflicts on your network. To
prevent this problem, make sure the same IP address does not exist
on the network before connecting the interface card to the network.
If the same IP address does exist, turn off the device which has the
same IP address, then change the default IP address of the interface
card. Be sure to ask your network administrator for the IP address,
subnet mask, and default gateway.
To set the IP address for OS/2 and UNIX, use the arp and ping
commands. For more information, see "Setting the IP Address
Using arp/ping Commands" on page 3-6.
Follow the steps below to set the IP address. The sample screens
are from the Windows 95 operating system using EpsonNet
WinAssist. Other systems differ in appearance, but the
instructions are the same, except as noted.
1. Confirm that the necessary protocols are installed on the
computer.
If you are using Windows Me/98/95/2000/NT, TCP/IP
must be installed. For Macintosh, AppleTalk must be
installed.
2. Turn on the printer with the interface card.
3-2
Setting the IP Address
Advertisement
Table of Contents
