Changing The Ip Address Using Epsonnet Webassist - Epson EpsonNet C82391 Series Administrator's Manual

Epsonnet 10/100 base tx int. print server 2
Table of Contents

Advertisement

3. The interface card should now respond to the ping. If it does
not, you may have incorrectly typed the MAC address or the
IP address in the arp -s command. Double-check and try
again. If none of these actions are effective, re-initialize the
interface card and try again.
4. Print a status sheet to check whether the new IP address has
been assigned to the interface card.
Note:
When you set the IP address of the interface card in this way, you
cannot change the subnet mask or the gateway setting of the interface
card. You must use EpsonNet WinAssist on Windows (Me, 98, 95,
2000, or NT), EpsonNet MacAssist in Macintosh, or EpsonNet
WebAssist to change these parameters.

Changing the IP Address Using EpsonNet WebAssist

After you have configured the interface card for TCP/IP using
EpsonNet WinAssist, MacAssist, or the arp/ping commands, you
can make changes to the IP address or other settings using
EpsonNet WebAssist (a utility that runs on your browser).
Note:
A web browser must be installed in your computer.
TCP/IP must be correctly set for the computer and the interface card.
Do not operate EpsonNet WinAssist/MacAssist and EpsonNet
WebAssist for the printer at the same time.
There are some restrictions on the characters you can use depending
on your browser. For details, see your browser or OS
documentation.
Follow the steps below to change the IP address using EpsonNet
WebAssist.
Setting the IP Address
3
3-9

Advertisement

Table of Contents
loading

Table of Contents