Configuring the Interface Card
To configure the interface card, you must complete the following
steps. See the indicated documentation for more detailed
information.
1. Install the interface card in your printer and connect it on the
network. See Chapter 1.
2. Install EpsonNet WinAssist or MacAssist. See the
supplemental sheet shipped with the CD-ROM. Or you can
use the EpsonNet Easy Setup to configure the interface card
without installing EpsonNet WinAssist. See Chapter 2.
3. Set the IP address for the interface card. See Chapter 3.
4. Configure the interface card using EpsonNet WinAssist,
MacAssist, or WebAssist and set up the printer. See the
appropriate chapter for your network environment.
5. Use EpsonNet Direct Print to print from TCP/IP. See Chapter
11.
6. Use EPSON Status Monitor 2 to monitor printer status. See
Chapter 12.
7. Use EpsonNet Internet Print to print using the Internet
Printing Protocol (IPP). See Chapter 13.
8. Use Printer Status Page to monitor printer status through the
Internet. See Chapter 14.
8
Introduction