Making Status Monitor Settings - Epson EpsonNet C82391 Series Administrator's Manual

Making Status Monitor Settings

You can change the settings in EPSON Status Monitor 2 as
described below.
1. Open the Run dialog box from the Start menu or the Control
Panel depending on your system. Enter the path to the
directory where you installed the Status Monitor, followed by
Setup. Then click OK.
When you have installed the program in directory ESM2 of
drive C, type C:\ESM2\SETUP.
Note:
If you installed the program in a directory other than ESM2, enter
the path to the directory instead of ESM2. If you installed the
program in drive C, type C:\[path]\SETUP. Substitute the
appropriate drive letter as necessary.
2. Follow the on-screen instructions.
Note for Windows 2000, NT 4.0, and NT 3.51:
Users can individualize their own settings without affecting the settings
of other users.
EPSON Status Monitor 2 (Windows only)
12
12-11