How to Set the UB-R03
There are two ways to set the UB‐R03.
• Setting with the USB connection
Connect the computer to the USB connector (Parameter Setting) of the TM printer with the
USB cable. This setting is possible without connecting to the network. Moreover, you can
check the wireless LAN setting at any time, and if you make a mistake in the setting, you can
correct it easily. This setting is recommended.
• Setting with the wireless LAN connection
Prepare the setting computer for wireless LAN and set it with the wireless LAN. If a setting
that cannot be communicated in the wireless LAN environment of the computer is set, the
connection is cut while setting and you cannot check the setting. Also the wrong setting can
prevent communication.
When you set up the access point at the same time, set the access point in advance and
check that the UB-R03 operates correctly.
Setting using the USB connection
Setting the UB‐R03 by connecting the computer to the USB connector (Parameter Setting) using
the USB cable.
Procedure for setting the UB-R03 using the USB connection
The preparation of the computer and the acquisition of the
information
Install the TMNet WinConfig V3 in the computer used for the setting,
and download the set up information.
Connect the UB-R03 to the computer and set the wireless LAN setting.
Confirm the operation of the UB-R03 using a Web browser.
26
Setting of the UB-R03
Confirming the operation