Table of Contents
Advertisement
6. Enter your password (up to 20 characters) and click OK to
save settings. If you are entering a password for the first time,
click Change and set the password. For more information
about passwords, see "About passwords" on page 10-7.
Follow the on-screen instructions. After updating is complete,
refresh the configuration by selecting Refresh from the View
menu.
c
Configuring for NetBEUI using EpsonNet WebAssist
Note:
A web browser must be installed in your computer.
TCP/IP must be correctly set for the computer and the interface card.
Do not operate EpsonNet WinAssist and EpsonNet WebAssist for
the printer at the same time.
There are some restrictions on the characters you can use depending
on your browser. For details, see your browser or OS
documentation.
1. Turn on the printer with the interface card.
2. Run EpsonNet WebAssist by either of the methods described
below.
Run EpsonNet WinAssist. Click the printer you want to
configure from the list and click Launch Browser.
Open your browser, and type in the IP address of the
interface card directly. Do not run EpsonNet WinAssist.
http://IP address of interface card/
5-6
Settings for Windows Me/98/95
Caution:
Since it takes 2 or 3 minutes to send new settings to the
interface card, you must wait until the on-screen message
appears before turning off your printer.
Advertisement
Table of Contents
