HP Surestore Disk Array 12h - And FC60 Service Manual page 362

Status
AM60: DEGRADED--REPLACED
DISK BEING REBUILT
STM: DEGRADED - 2
AM60: DEAD--MORE DISK
FAILURES THAN REDUNDANT
DISKS
STM: UNAVAILABLE - 4
AM60: DEAD--FORMAT IN
PROGRESS
STM: BINDING
AM60: UNDEFINED
STM: DEGRADED - 83 OR
UNAVAILABLE - 83
AM60: DEAD--CREATION IN
PROGRESS
STM: UNAVAILABLE - 84
AM60: DEAD--WRONG DISK
REMOVED OR REPLACED
STM: UNAVAILABLE - 116
AM60: INACCESSIBLE:POSSIBLY
NO DEVICE FILE
STM: UNAVAILABLE - 254
AM60: UNDEFINED
STM: UNAVAILABLE - xxx
362
Definition/Action
A rebuild is in progress on the LUN.
No action is required.
Multiple, simultaneous disk failures have occurred on the
LUN, causing data to be inaccessible. On a RAID 5 LUN,
losing more than one disk will cause this status. On a RAID
1 or 0/1 LUN, you must lose both disks of a mirrored pair
before this status will occur.
Replace the failed disks.
A formatting operation (writing zeros) is in progress on a
DEAD LUN. This occurs while the LUN is being bound.
No action is required.
This state indicates a drive failure during a LUN binding
process. If a hot spare has been designated, the LUN state
should transition to Optimal once the LUN binding is
complete. If no hot spare is in place, the LUN state should
transition to Degraded--Waiting for Repair Action
(Degraded--1), once the binding is complete.
A formatting operation has been queued for this LUN, but
has not started yet.
No action is required.
The wrong disk was removed from a degraded LUN.
Reinstall the disk.
The special device files are not installed on the LUN.
Run insf -e on the LUN.
The LUN is in an unknown state.
Contact your service representative.