Raidvchkscan For Continuous Access Journal; Syntax - HP StorageWorks P9000 - Disk Arrays Reference Manual

D: "C" flag cannot be changed to enable.
R=E: "R" flag can be changed to enable.
D: "R" flag cannot be changed to enable.
W=E: "W" flag can be changed to enable.
D: "W" flag cannot be changed to enable.
S=E: "S" flag can be changed to enable.
D: "S" flag cannot be changed to enable.
R-Time: Displays the retention time for write protect, in units of day. The hyphen (-) shows that the
retention time is infinite. The application knows whether the target volume is denied to change to
writing enable by referring "R-Time".
Audit lock status is shown as the retention time plus 1000000. "R-Time + 1000000" shows the
retention time with Audit lock status.
Example 5: raidvchkscan command example with the -v pool option
# raidvchkscan -v pool -p CL2-d-0
PORT# /ALPA/C TID# LU#
CL2-D-0 /e4/ 0
CL2-D-0 /e4/ 0
Output of the raidvchkscan command with -v pool option:
Bsize: Displays the data block size of the pool, in units of block (512 bytes).
Available(Bsize): Displays the available capacity for the volume data on the Snapshot pool in units
of Bsize.
Capacity(Bsize): Displays the total capacity in the Snapshot pool in units of Bsize.
Example 5: raidvchkscan command example with the -v aou option
# raidvchkscan -v aou -p CL2-d-0
PORT# /ALPA/C TID# LU#
CL2-D-0 /e4/ 0
CL2-D-0 /e4/ 0
Output of the raidvchkscan command with -v aou option:
Used(MB): Displays the usage size the allocated block on this LUN. Range: 0 ≤ Used (MB) <
LU_CAP(MB) + 42MB
LU_CAP(MB): Displays the LUN capacity responded to the "Readcapacity" command as SCSI
interface.
LU_CAP(BLK): Displays the LUN capacity (in block/512 bytes) responded to the "Readcapacity"
command as SCSI interface.
U(%): Displays the usage rate of the allocated block on the Thin Provisioning pool containing this
LU.
T(%): Displays the threshold rate being set to the Thin Provisioning pool as high water mark.
PID: Displays the Thin Provisioning pool ID assigned to this Thin Provisioning volume.

raidvchkscan for Continuous Access Journal

The raidvchkscan command supports the (-v jnl [t] [unit#]) option to find the journal volume list
setting via SVP. It also displays any information for the journal volume.

Syntax

raidvchkscan {
| -v
90 Replication commands
Seq#
2 0 62500
2 1 62500
Seq# Num LDEV#
2 0 62500
2 1 62500
-h | -q | -z | -I[H][M][instance#] or I[TC][SI][instance#]
jnl [t] [unit#] | [ -s <Seq#>] |
Num LDEV# Bsize
1 160 2048
1 161 2048
Used(MB) LU_CAP(MB)
1 160 20050
1 161 200500
[ -f[x ] | }
Available
100000 1000000000
100000 1000000000
U(%) T(%) PID
1100000 1 60
1100000 18 60
Capacity
1
2