Raidcom Modify Journal - HP StorageWorks P9000 - Disk Arrays Reference Manual

DOW
This displays "Data Overflow Watch" timer (in unit of Sec.) setting per the Journal.
PBW
This displays "Path Blockade Watch" (in unit of Sec.) timer setting per the Journal. If the setting is
more than 3600 seconds, it displays 6000 seconds.
APW
It shows "Active Path Watch" (in unit of Sec.) timer setting to detect any link failures.
TYPE
This displays a type for "Open" or "M/F" system.
TTYPE
This displays the timer type for M/F.
- system: using System timer.
- local: using Local timer.
MODE
This displays the status of the journal.
- HDD: Store the journal data to the journal volume (cache mode disabled).
- CACHE: Store the journal data to the cache (cache mode enabled).
IF
This displays the inflow control for journal.
E: Enable, D: Disable
DOW(S)
This displays "Data Overflow Watch" timer (in unit of Sec.) setting per the Journal.
PBW(M)
This displays "Path Blockade Watch" (in unit of Min.) timer setting per the Journal. If the setting is
more than 60 minutes, it displays 100 minutes.
CR
This displays the copy rate as "Low/Medium/High".
CS(bps)
This displays the copy speed as "10/100/256".
DM
This displays the copy mode as "Y/N" under failure of the delta resync.
- Y: copying ALL data.
- N: No copying.
MP#
This displays MP Blade ID.

raidcom modify journal

Changes an option of Cnt Ac-J to be used at journal.
It sets a specified control parameter to the journal.
If the -mp_blade_id option is specified, the other option (-data_overflow_watch, -
path_blocked_watch, -cache_mode, -timer_type) cannot be specified.
"-timer_type" option must be specified to the journal on "M/F System".
This means that this option cannot be used for changing from "Open System" to "M/F System."
raidcom modify journal 149