Raidcom Get Snap_Pool; Syntax; Options And Parameters; Examples - HP StorageWorks P9000 - Disk Arrays Reference Manual

Using LDEV belonging to the device group: grp1, creating a pool of Pool ID: 1, Pool Name:
Allocated automatically for Snapshot.
raidcom add snap_pool -pool_id 1 -grp_opt ldev -device_grp_name grp1

raidcom get snap_pool

Displays pool information for Snapshot.

Syntax

raidcom get snap_pool

Options and parameters

None

Examples

Displaying pool information for Snapshot.
raidcom get snap_pool
ID POLS U(%) SSCNT Available(MB) Capacity(MB) Seq# Num LDEV# H(%)
003 POLS 100 10000
Description on each column in output example
PID
This displays the pool ID.
POLS
This displays the following status of the pool.
- POLN: "Pool Normal" (The pool is in the normal status.)
- POLF: "Pool Full" (The pool is in the overflow status exceeding the threshold.)
- POLS: "Pool Suspend" (The pool is in the overflow status exceeding the threshold and is suspended.)
- POLE: "Pool failure" (The pool is suspended in the failure status.) In this status, the pool information
cannot be displayed.
U(%)
This displays the usage rate of the pool.
SSCNT
This displays the number of volumes in the pool.
Available (MB)
This displays the available capacity for the volumes data on the pool.
Capacity (MB)
This displays the total capacity of the pool.
Seq#
Sequential number.
Num
This displays the number of LDEVs configuring the pool.
LDEV#
This displays the first number of the LDEV configuring the pool.
H (%)
This displays the threshold value for a pool.
186 Configuration setting commands
100 1000000000 62500 1 375 70