Raidcom Add Lun; Options And Parameters; Examples - HP StorageWorks P9000 - Disk Arrays Reference Manual

Options and parameters

Option
-ldev_id <ldev#>
-status <status>
ldev_name <ldev
naming>
-mp_blade_id <mp#>

Examples

Restoring the LDEV: 200.
raidcom modify ldev -status nml -ldev_id 200
Blocking the LDEV: 200.
raidcom modify ldev -status blk -ldev_id 200
Assigning an LDEV nickname: my_volume to LDEV:200
raidcom modify ldev -ldev_id 200 -ldev_name my_volume
Setting the LDEV owner MP Blade ID of LDEV: 200 to 2
raidcom modify ldev -ldev_id 200 -mp_blade_id 2
Enabling reallocation of LDEV(Smart Tiers V-VOL) :200
raidcom modify ldev -ldev_id 200 -status enable_reallocation
Disabling reallocation of LDEV(Smart Tiers V-VOL) :200
raidcom modify ldev -ldev_id 200 -status disable_reallocation
Discarding of the 0 page of LDEV(Thin Provisioning/Smart Tiers V-VOL):200
raidcom modify ldev -ldev_id 200 -status discard_zero_page

raidcom add lun

To set the LU path, this maps LDEV to the LUN on the host group on the specified port, and then
creates LUN path or alternative path. A device group can also be specified instead of an LDEV.
If the specified port and host group does not exist, it will be rejected with EX_ENOOBJ(EX_CMDRJE).
Description
Specifies an LDEV number (0-65279).
For example:
-ldev_id 200
Specifies an LDEV status.
The following LDEV statuses can be specified:.
nml: Changes the LDEV status to Normal.
blk: Changes the LDEV status to Blockade.
enable_reallocation: Reallocation of LDEV(V-VOL) for Smart Tiers enabled.
disable_reallocation: Reallocation of LDEV(V-VOL) for Smart Tiers disabled.
discard_zero_page: Discarding 0 page of LDEV(V-VOL) for Thin Provisioning/Smart Tiers
For example:
-status nml
Specifies an LDEV nickname (max. 32 characters).
Specifies an MP Blade ID (0-7).
Changing MP Blade ID should be executed during off-peak hours of I/O loading. Do not
change the MP blade ID during initial copying of Continuous Access Synchronous, Business
Copy or Continuous Access Journal (on-peak hours of I/O loading).
To change the MP Blade ID again for the same LDEV, wait for more than 30 minutes after
changing the MP Blade ID.
For example:
-mp_blade_id 2
raidcom add lun 161