Pairsyncwait - HP StorageWorks P9000 - Disk Arrays Reference Manual

# horctakeoff -g G1 -gs G3
horctakeoff : 'pairsplit -g G1 -S -FHORC 1' is in progress.
horctakeoff : 'pairsplit -g G1' is in progress.
horctakeoff : 'pairsplit -g G3 -S' is in progress.
horctakeoff : 'paircreate -g G1 -gs G3 -FHORC 1 -nocopy -f async -jp 0 -js 1' is in progress.
horctakeoff : 'pairsplit -g G1 -FHORC 1' is in progress.
horctakeoff : 'pairresync -g G1' is in progress.
horctakeoff : 'pairresync -g G1 -FHORC 1' is in progress.
horctakeoff : horctakeoff done.
Example 3
horctakeoff command on L1 remote site
# horctakeoff -g G1 -gs G2
horctakeoff : 'pairsplit -g G2 -S' is in progress.
horctakeoff : 'pairsplit -g G1' is in progress.
horctakeoff : 'pairsplit -g G1 -FHORC 2 -S' is in progress.
horctakeoff : 'paircreate -g G2 -vl -nocopy -f async -jp 0 -js 1' is in progress.
horctakeoff : 'pairsplit -g G2' is in progress.
horctakeoff : 'pairresync -g G1' is in progress.
horctakeoff : 'pairresync -g G2' is in progress.
horctakeoff : horctakeoff done.
Example 4
horctakeoff command on L2 remote site
# horctakeoff -g G1 -gs G3
horctakeoff : 'pairsplit -g G3 -S' is in progress.
horctakeoff : 'pairsplit -g G1' is in progress.
horctakeoff : 'pairsplit -g G1 -FHORC 1 -S' is in progress.
horctakeoff : 'paircreate -g G3 -vl -nocopy -f async -jp 0 -js 1' is in progress.
horctakeoff : 'pairsplit -g G3' is in progress.
horctakeoff : 'pairresync -g G1' is in progress.
horctakeoff : 'pairresync -g G3' is in progress.
horctakeoff : horctakeoff done.

pairsyncwait

The pairsyncwait command is used to confirm data consistency between the Continuous Access
Asynchronous/Cnt Ac-J P-VOL and S-VOL by confirming that required writing was stored in the
DFW area of RCU, and confirming whether the last writing just before this command reached the
RCU DFW area.
This command gets the latest sequence # of the MCU sidefile (P-VOL latest sequence # within the
CT group ID) and the sequence # of the RCU DFW within the CT group ID corresponding to the
<group> or <raw_device> specified by pairsyncwait, and compares the MCU with the RCU
sequence # at that time and at regular intervals. If the RCU sequence # is over the value of the
MCU sequence # within the term specified by pairsysncwait, this command displays the return
code 0 with the meaning of completion of synchronization. The -nowait option shows the latest
sequence # (Q-marker) of MCU PVol and CTGID. The marker is shown in hexadecimal of 10
characters.
pairsyncwait 101