Returned Values - HP StorageWorks P9000 - Disk Arrays Reference Manual

Option
-ss
-nomsg
-FHORC [MU#]
or -FCA [MU#]
-FMRCF [MU#]
or -FBC [MU#]:
-MINAP

Returned values

The pairvolchk command sets the following returned values during exit, allowing you to check the
execution results.
Table 14 pairvolchk returned values
Condition
When the -ss
option is not
specified
When the -ss
option is specified
48 Replication commands
Description
Used when acquiring the attribute of a volume and the pair status of a volume. If this option is not
specified, the volume attribute is reported.
Suppresses messages to be displayed when this command is executed. It is used to execute a
command from a user program. This option must be specified at the beginning of a command
argument. The command execution log is not affected by this option.
Forcibly specifies a cascading Continuous Access Synchronous volume for specified pair logical
volumes on Business Copy environment. If no -c option is specified, this option acquires the attributes
of a cascading Continuous Access Synchronous volume on a local host (near site). If the -c option is
specified, this option acquires the attributes of a cascading Continuous Access Synchronous volume
on a remote host (far site).
Forcibly specifies a cascading Business Copy volume for specified pair logical volumes on Continuous
Access Synchronous environment. If no -c option is specified, acquires the attributes of a cascading
Business Copy volume on a local host (near site). If the -c option is specified, acquires the attributes
of a cascading Business Copy volume on a remote host (far site).
Shows the minimum active paths on specified group in HORC/HORCAsync on P-VOL.
NOTE: If RAID F/W is not supporting the number of active paths, then "MINAP" item is not displayed
as follows.
pairvolchk : Volstat is P-VOL.[status = PAIR fence = ASYNC CTGID = 2]
See examples below.
Value
Normal termination:
1: The volume attribute is SMPL.
2: The volume attribute is P-VOL.
3: The volume attribute is S-VOL.
Abnormal termination: Other than 0 to 127, see the execution log files for error details.
Normal termination:
1 1: The status is SMPL.
Abnormal termination: Specific error codes (see Error codes) and generic error codes.