MikroTik RouterOS v2.9 Reference Manual page 674

Property Description
name ( name ) - name given by the user or the default one
autodial ( integer ; default: "" ) - phone number which will be dialed immediately after the
handset has been lifted. If this number is incomplete, then the remaining part has to be dialed on the
dial-pad. If the number is incorrect, the line is hung up (FXO "line" port) or busy tone is played
(FXS "phone" port). If the number is correct, then the appropriate number is dialed. If it is an
incomming call from the PSTN line, then the direct-call mode is used - the line is picked up only
after the remote party answers the call
playback-volume ( integer : -48 ..48 ; default: 0 ) - playback volume in dB
• 0 - 0dB meand no change to signal level
record-volume ( integer : -48 ..48 ; default: 0 ) - record volume in dB
• 0 - 0dB meand no change to signal level
ring-cadence ( text ) - a 16-symbol ring cadence for the phone, each symbol lasts 0.5 seconds, +
means ringing, - means no ringing
region ( name ; default: us ) - regional setting for the voice port. This setting is used for setting the
parameters of PSTN line, as well as for detecting and generating the tones
aec ( yes | no ) - whether echo detection and cancellation is enabled
aec-tail-length ( short | medium | long ; default: short ) - size of the buffer of echo detection
aec-nlp-threshold ( off | low | medium | high ; default: low ) - level of cancellation of silent sounds
aec-attenuation-scaling ( integer : 0 ..10 ; default: 4 ) - factor of additional echo attenuation
aec-attenuation-boost ( integer : 0 ..90 ; default: 0 ) - level of additional echo attenuation
software-aec ( yes | no ) - software echo canceller (experimental, for most of the cards)
agc-on-playback ( yes | no ; default: no ) - automatic gain control on playback (can not be used
together with hardware voice codecs)
agc-on-record ( yes | no ; default: no ) - automatic gain control on record (can not be used together
with hardware voice codecs)
detect-cpt ( yes | no ; default: no ) - automatically detect call progress tones
Command Description
blink - blink the LEDs of the specified voice port for five seconds after it is invoked. This
command can be used to locate the respective card from several linejack cards ( name ) - card name
to blink the LED of
clear-call - terminate a current call established with the specified voice port ( name ) - port name to
clear call with
show-stats - show voice port statistics ( name ) - port name show statistics of ( time ) - maximal
time of packet round trip ( integer ) - number of packets sent by this card (these packets are
digitalized input of the voice port) ( integer ) - number of bytes sent by this card (these packets are
digitalized input of the voice port) ( text ) - minimal/average/maximal intervals between packets
sent ( integer ) - number of packets received by this card (these packets form analog output of the
voice port) ( integer ) - number of bytes received by this card (these packets form analog output of
the voice port) ( text ) - minimal/average/maximal intervals between packets received ( time ) -
Page 660 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.