Eoip Application Example - MikroTik RouterOS v2.9 Reference Manual

Property Description
arp ( disabled | enabled | proxy-arp | reply-only ; default: enabled ) - Address Resolution Protocol
mac-address ( MAC address ) - MAC address of the EoIP interface. You can freely use MAC
addresses that are in the range from 00-00-5E-80-00-00 to 00-00-5E-FF-FF-FF
mtu ( integer ; default: 1500 ) - Maximum Transmission Unit. The default value provides maximal
compatibility
name ( name ; default: eoip-tunnelN ) - interface name for reference
remote-address - the IP address of the other side of the EoIP tunnel - must be a MikroTik router
tunnel-id ( integer ) - a unique tunnel identifier
Notes
tunnel-id is method of identifying tunnel. There should not be tunnels with the same tunnel-id on
the same router. tunnel-id on both participant routers must be equal.
mtu should be set to 1500 to eliminate packet refragmentation inside the tunnel (that allows
transparent bridging of Ethernet-like networks, so that it would be possible to transport full-sized
Ethernet frame over the tunnel).
When bridging EoIP tunnels, it is highly recommended to set unique MAC addresses for each
tunnel for the bridge algorithms to work correctly. For EoIP interfaces you can use MAC addresses
that are in the range from 00-00-5E-80-00-00 to 00-00-5E-FF-FF-FF, which IANA has reserved
for such cases. Alternatively, you can set the second bit of the first byte to mark the address as
locally administered address, assigned by network administrator, and use any MAC address, you
just need to ensure they are unique between the hosts connected to one bridge.
Example
To add and enable an EoIP tunnel named to_mt2 to the 10.5.8.1 router, specifying tunnel-id of 1:
[admin@MikroTik] interface eoip> add name=to_mt2 remote-address=10.5.8.1 \
\... tunnel-id 1
[admin@MikroTik] interface eoip> print
Flags: X - disabled, R - running
0 X name="to_mt2" mtu=1500 arp=enabled remote-address=10.5.8.1 tunnel-id=1
[admin@MikroTik] interface eoip> enable 0
[admin@MikroTik] interface eoip> print
Flags: X - disabled, R - running
0 R name="to_mt2" mtu=1500 arp=enabled remote-address=10.5.8.1 tunnel-id=1
[admin@MikroTik] interface eoip>

EoIP Application Example

Description
Let us assume we want to bridge two networks: 'Office LAN' and 'Remote LAN'. The networks are
connected to an IP network through the routers [Our_GW] and [Remote]. The IP network can be a
private intranet or the Internet. Both routers can communicate with each other through the IP
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
Page 299 of 695