Isdn Client Interface Configuration - MikroTik RouterOS v2.9 Reference Manual

name ( name ) - name of the driver
isdn-protocol ( euro | german ; default: euro ) - data channel protocol
ISDN Channels
ISDN channels are added to the system automatically when the ISDN card driver is loaded. Each
channel corresponds to one physical 64K ISDN data channel.
The list of available ISDN channels can be viewed using the /isdn-channels print command. The
channels are named channel1, channel2, and so on. E.g., if you have two ISDN channels, and one
of them currently used by an ISDN interface, but the other available, the output should look like
this:
[admin@MikroTik] isdn-channels> print
Flags: X - disabled, E - exclusive
# NAME
0 channel1
1 channel2
[admin@MikroTik] isdn-channels>
ISDN channels are very similar to PPP serial ports. Any number of ISDN interfaces can be
configured on a single channel, but only one interface can be enabled for that channel at a time. It
means that every ISDN channel is either available or used by an ISDN interface.
MSN and EAZ numbers
In Euro-ISDN a subscriber can assign more than one ISDN number to an ISDN line. For example,
an ISDN line could have the numbers 1234067 and 1234068. Each of these numbers can be used to
dial the ISDN line. These numbers are referred to as Multiple Subscriber Numbers (MSN).
A similar, but separate concept is EAZ numbering, which is used in German ISDN networking.
EAZ number can be used in addition to dialed phone number to specify the required service.
For dial-out ISDN interfaces, MSN/EAZ number specifies the outgoing phone number (the calling
end). For dial-in ISDN interfaces, MSN/EAZ number specifies the phone number that will be
answered. If you are unsure about your MSN/EAZ numbers, leave them blank (it is the default).
For example, if your ISDN line has numbers 1234067 and 1234068, you could configure your
dial-in server to answer only calls to 1234068 by specifying 1234068 as your MSN number. In a
sense, MSN is just your phone number.

ISDN Client Interface Configuration

Home menu level: /interface isdn-client
Description
The ISDN client is used to connect to remote dial-in server (probably ISP) via ISDN. To set up an
ISDN dial-out connection, use the ISDN dial-out configuration menu under the submenu.
Property Description
name ( name ; default: isdn-outN ) - interface name
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
CHANNEL DIR.. TYPE
0
1
PHONE
Page 207 of 695