MikroTik RouterOS v2.9 Reference Manual page 185

Try to change the I/O base address using the DIP switches
Property Description
ap1 ( MAC address ) - forces association to the specified access point
ap2 ( MAC address ) - forces association to the specified access point
ap3 ( MAC address ) - forces association to the specified access point
ap4 ( MAC address ) - forces association to the specified access point
arp ( disabled | enabled | proxy-arp | reply-only ; default: enabled ) - Address Resolution Protocol
beacon-period ( integer : 20 ..976 ; default: 100 ) - Specifies beaconing period (applicable to
ad-hoc mode only)
card-type ( read-only: text ) - your CISCO/Aironet adapter model and type
client-name ( text ; default: "" ) - client name
data-rate ( 1Mbit/s | 2Mbit/s | 5.5Mbit/s | 11Mbit/s | auto ; default: 1Mbit/s ) - data rate in Mbit/s
fragmentation-threshold ( integer : 256 ..2312 ; default: 2312 ) - this threshold controls the packet
size at which outgoing packets will be split into multiple fragments. If a single fragment transmit
error occurs, only that fragment will have to be retransmitted instead of the whole packet. Use a low
setting in areas with poor communication or with a great deal of radio interference
frequency - Channel Frequency in MHz (applicable to ad-hoc mode only)
join-net ( time ; default: 10 ) - an amount of time,during which the interface operating in ad-hoc
mode will try to connect to an existing network rather than create a new one
• 0 - do not create own network
long-retry-limit ( integer : 0 ..128 ; default: 16 ) - specifies the number of times an unfragmented
packet is retried before it is dropped
mode ( infrastructure | ad-hoc ; default: infrastructure ) - operation mode of the card
modulation ( cck | default | mbok ; default: cck ) - modulation mode
• cck - Complementary Code Keying
• mbok - M-ary Bi-Orthogonal Keying
mtu ( integer : 256 ..2048 ; default: 1500 ) - Maximum Transmission Unit
name ( name ) - descriptive interface name
rts-threshold ( integer : 0 ..2312 ; default: 2312 ) - determines the packet size at which the
interface issues a request to send (RTS) before sending the packet. A low value can be useful in
areas where many clients are associating with the access point or bridge, or in areas where the
clients are far apart and can detect only the access point or bridge and not each other
rx-antenna ( both | default | left | right ; default: both ) - receive antennas
short-retry-limit ( integer : 0 ..128 ; default: 16 ) - specifies the number of times a fragmented
packet is retried before it is dropped
ssid1 ( text ; default: tsunami ) - establishes the adapter's service set identifier This value must
match the SSID of the system in order to operate in infrastructure mode
ssid2 ( text ; default: "" ) - service set identifier 2
ssid3 ( text ; default: "" ) - service set identifier 3
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
Page 171 of 695