Monitoring The Interface Status; Troubleshooting - MikroTik RouterOS v2.9 Reference Manual

Reference manual
Table of Contents

Advertisement

Flags: X - disabled, D - dynamic, R - running
#
NAME
0
R ether1
[admin@MikroTik] > interface ethernet
[admin@MikroTik] interface ethernet> print
Flags: X - disabled, R - running
#
NAME
0
R ether1
[admin@MikroTik] interface ethernet> print detail
Flags: X - disabled, R - running
0
R name="ether1" mtu=1500 mac-address=00:0C:42:03:00:F2 arp=enabled
disable-running-check=yes auto-negotiation=yes full-duplex=yes
cable-settings=default speed=100Mbps
[admin@MikroTik] interface ethernet>

Monitoring the Interface Status

Command name: /interface ethernet monitor
Property Description
status ( link-ok | no-link | unknown ) - status of the interface, one of the:
• link-ok - the card has connected to the network
• no-link - the card has not connected to the network
• unknown - the connection is not recognized
rate ( 10 Mbps | 100 Mbps | 1 Gbps ) - the actual data rate of the connection
auto-negotiation ( done | incomplete ) - fast link pulses (FLP) to the adjacent link station to
negotiate the SPEED and MODE of the link
• done - negotiation done
• incomplete - negotiation failed
full-duplex ( yes | no ) - whether transmission of data occurs in two directions simultaneously
Notes
See the
IP Addresses and ARP
the interfaces.
Example
[admin@MikroTik] interface ethernet> monitor ether1,ether2
status: link-ok link-ok
auto-negotiation: done
rate: 100Mbps 100Mbps
full-duplex: yes

Troubleshooting

Description
Interface monitor shows wrong information
In some very rare cases it is possible that the device driver does not show correct information,
Page 186 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
TYPE
ether
MTU
1500
section of the manual for information how to add IP addresses to
done
yes
RX-RATE
TX-RATE
0
0
MAC-ADDRESS
00:0C:42:03:00:F2 enabled
MTU
1500
ARP

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RouterOS v2.9 and is the answer not in the manual?

Table of Contents

Save PDF