Connecting The On-Board Thermistor - VXI VT1422A User Manual

Connecting the On-Board Thermistor

J1
ON
BOARD
Chapter 2
The following figures show how to use the VT1422A to make temperature
measurements using the on-board Thermistor or a remote reference sensor.
The Thermistor is used for reference junction temperature sensing for thermocouple
measurements. Figure 2-12 shows the configuration for the VT1422A's Spring
Terminal Module, Figure 2-6 shows the configuration for the Screw Terminal
Module. See "Reference Temperature Sensing with the VT1422A" on page 44 for
a schematic diagram of the reference connections.
Under Cove r
REM
J1
ON
BOARD
REM
See Figure 2-13 on page 50 to remove the cover
Figure 2-12. Temperature Sensing for the Terminal Module
J1
ON
BOARD
REM
ON BOARD
Place both J1 jumpers here to
connect current source to
on-board thermistor RT1. Sense
RT1 by connecting any sense
channels to terminals HTS and
LTS.
REMote
Place both J1 jumpers here to
route current source to terminals
HTI and LTI. Connect these
terminals to remote thermistor or
RTD. Sense with any sense
channel.
Field Wiring 49