MEMory:VME:STATe
Parameters
Comments
Usage
MEMory:VME:STATe?
Comments
Usage
Chapter 7
MEMory:VME:STATe <enable>
as additional reading storage.
Parameter
Parameter
Name
Type
enable
boolean (uint16)
•
This command is only available in systems using an Agilent/HP E1405B/06A
command module.
•
When the VME memory card is enabled, the INIT command does not terminate
until data acquisition stops or VME memory is full.
•
Related Commands: Memory subsystem and FETCH?
•
*RST Condition: MEM:VME:STAT OFF
MEMORY:VME:STATE ON
MEM:VME:STAT 0
MEMory:VME:STATe?
is disabled. Returned value of 1 indicates VME memory is enabled.
•
This command is only available in systems using an Agilent/HP E1405B/06A
command module.
•
Returned Value: Numeric 1 or 0. data type uint16.
•
Related Commands: MEMory subsystem and FETCH?
MEM:VME:STAT?
enables or disables use of the VME memory card
1 | 0 | ON | OFF
enable VME card as reading storage
Disable VME card as reading storage
returned value of 0 indicates that VME reading storage
Returns 1 for enabled, 0 for disabled
VT1422A Command Reference
MEMory
Range of
Values
Default
Units
none
311