Vt1529A/B Verification & Calibration; Introduction; Recommended Equipment; Dummy Load - VXI VT1422A User Manual

VT1529A/B Verification & Calibration

Introduction

Recommended
Equipment
Instrument
GPIB Controller
VXI card cage and
slot 0
Programmable D/A
Converter
Digital Multimeter
Precision
Calibration Source

Dummy Load

*A = Adjustments, V= Verification Tests
Dummy Load
Appendix C
This appendix describes the verification and calibration procedure for the
VT1529A/B Remote Strain Conditioning Unit when used with the
VT1422A and the VT1539A SCP.
Note
The verification and calibration procedure for the VT1422A and all SCPs
other than the VT1539A is identical to the procedures for the VT1415A
Algorithmic Closed Loop Controller. The procedures and programs
described in the VT1415A and VT1419A Service Manual should be used to
verify and calibrate the VT1422A and the other SCPs. Please contact
VXI Technology
See the table below for test equipment recommended to test and service the
VT1529A/B. Essential requirements for each piece of test equipment are
listed in the Requirements column. Other equipment may be substituted if it
meets the requirements listed in the table.
Requirements
Pentium II 450 MHz or faster PC
with GPIB card
Compatible with Agilent/HP
E1406A Command Module
Frequency ≥ 2 kHz
Voltage Range: ±20 V dc
Resistance Range: 1 MΩ
Current Range: 100 µA to 1 mA dc
Voltage Range: 5.000 V dc
See "Dummy Load" below
Many of the tests require that a dummy load be connected to the
VT1529A/B channel(s) being tested. With only one dummy load, each
channel must be tested separately. This will take a long time, so it is
recommended that one load be created for each channel on a VT1529A/B so
that all channels can be tested simultaneously.
for service manual availability.
GPIB = 82350A or 82357A
Agilent I/O Libraries
Agilent/HP E1406A
VT1531A SCP for VT1422A
Agilent/HP 3458A
Fluke 5700
VT1529A/B Verification & Calibration
Appendix C
Recommended model Use*
V, A
V, A
V
V, A
V, A
V
463