Input:gain; Input:low; Input:gain? (@<Channel>); Input:low <Wvolt_Type>,(@<Ch_List>) - VXI VT1422A User Manual

INPut:GAIN?

Parameters
Comments
Usage

INPut:LOW

Parameters
Comments
Usage
Chapter 7
INPut:GAIN? (@<channel>)
channel is not on an input SCP, the query will return zero.
Parameter Parameter
Name Type
channel channel list (string)
•
The <channel> parameter must specify a single channel only.
•
If the channel specified does not have a programmable amplifier, INP:GAIN?
will return the nominal as-designed gain for that channel.
•
Returned Value: Numeric value as set by the INP:GAIN command.
The data type is float32.
•
When Accepted: Not while INITiated
•
Related Commands: INP:GAIN
•
*RST Condition: gain set to 1
•
Send with VXIplug&play Function: hpe1422_cmdReal64_Q(...)
INPUT:GAIN? (@105)
INP:GAIN? (@100)
INPut:LOW <wvolt_type>,(@<ch_list>)
Strain Bridge SCP channel specified by <ch_list>. LO can be connected to the
Wagner Voltage tap for quarter or half bridge configurations or disconnected for full
bridges. Note the VT1529A/B's Wagner Voltage connection is only controlled by
the command "[SENSe:]STRain:BRIDge[:TYPE]" on page 362.
Parameter Parameter
Name Type
wvolt_type discrete (string)
ch_list channel list (string)
•
Related Commands: INP:LOW?
•
*RST Condition: INP:LOW FLOAT (all Option 21 channels)
•
Send with VXIplug&play Function: hpe1422_cmd(...)
INP:LOW WVOL (@100:103,116:119)
returns the gain currently set for channel. If the
Range of
Values
100 - 163
Check gain on channel 5
Check gain on channel 0
controls the connection of input LO at a
Range of
Values
FLOat | WVOLtage
100 - 163
connect LO of channels 0 through 3 and
16 through 19 to Wagner Ground.
VT1422A Command Reference
INPut
Default
Units
none
Default
Units
none
none
301