[Sense:]Reference:temperature; Sense:reference:temperature; [Sense:]Reference:temperature <Degrees_C - VXI VT1422A User Manual

Parameters
Comments
Usage

[SENSe:]REFerence:TEMPerature

Note
Chapter 7
Parameter Parameter
Name Type
ref_channel channel list (string)
ch_list channel list (string)
•
Use SENS:FUNC:TEMP:POST to configure channels to measure thermocouples.
Then use SENS:REF:POST to configure one or more channels to measure an
isothermal reference temperature. Finally, use SENS:REF:CHAN:POST to
group the reference channel with its thermocouple measurement channels.
•
If thermocouple measurements are made through more than one isothermal
reference panel, set up a reference channel for each. Execute the
SENS:REF:CHAN:POST command for each reference/measurement channel
group.
•
Related commands: SENS:FUNC:TEMP:POST, SENS:REF:POST
•
*RST Condition: No channels are linked to references.
•
Send with VXIplug&play Function: hpe1422_cmd(...)
SENS:FUNC:TEMP:POST TC,J,.0625,(@10008:10015)
SENS:REF:POST THER,5000,4,(@10000),(@10001)
SENS:REF:CHAN (@10001),(@10008:10015)
ROUT:SEQ:DEF (@10008:10015,10001,10000)
[SENSe:]REFerence:TEMPerature <degrees_c>
temperature in the Reference Temperature Register. Use when the thermocouple
reference junction is kept at a controlled temperature.
This reference temperature is used to compensate all subsequent thermocouple
measurements until the register is overwritten by another SENSE:REF:TEMP value
or by scanning a channel linked with the SENSE:REFERENCE command. If used,
SENS:REF:TEMP must be executed before scanning any thermocouple channels.
Range of
Values
10000 - 15731
10000 - 15731
J type TCs on channels 8 through 15
sense the reference temperature on
ch 10001; excitation on ch 10000;
measure on 4 V range
link TC channels to thermistor
set up scan list
stores a fixed reference junction
VT1422A Command Reference
[SENSe]
Default
Units
none
none
359