Viewing Vcem And C-Class Enclosure Properties; Supported Configurations; Viewing Vcem Information; Sscm Vcem Configuration - HP 8/20q User Manual

9

Viewing VCEM and c-Class Enclosure Properties

This chapter provides procedures for viewing VCEM version 6.1 and c-Class Enclosure properties using
Simple SAN Connection Manager.

Supported configurations

• VCEM 6.1 and Virtual Connect Manager configured to the recommended HP guidelines (all servers
and SAN fabrics configured correctly and the VCM managed by VCEM)
NOTE:
management station.
• For SAN fabrics, SSCM supports both factory default and VC WWN addresses. With VC defined
WWN addresses, additional host to blade/bay associations are available.

Viewing VCEM information

Simple SAN Connection Manager provides easy access to information about VCEM within your SAN. Use
the VCEM Configuration dialog box to establish associations between each blade and their respective HP
BladeSystem c-Class Enclosure.
To log in and view VCEM configuration:
1. Start the Simple SAN Connection Manager. See
page 30.
2. Open the VCEM Configuration dialog box
3. Check in the Enable VCEM Discovery check box.
4. Enter the username and password, and then enter the IP address of the VCEM host server.
5. Click OK.
Figure 85

SSCM VCEM Configuration

HP recommends that VCEM 6.1 is installed on a different server from the SSCM
"Starting Simple SAN Connection Manager"
(Figure 85).
HP StorageWorks Simple SAN Connection Manager User Guide 111
on