Network Server Mode Active And No Keyboard Attached - HP ProLiant DL388 Troubleshooting Manual

CAUTION:
"Performing processor procedures in the troubleshooting process (on page 17)." Failure to follow
the recommended guidelines can cause damage to the system board requiring replacement of the
system board.
To use the installed DIMMs, install a processor in the corresponding socket.
Mismatched power supplies not supported
Audible Beeps: 1 long, 1 short
Possible Cause: The power supplies installed in the server are not supported in the current configuration. The
server does not support installing more than one type of power supply.
Action: Install supported power supplies in a supported configuration.
For supported power supply configurations, see the server documentation on the HP website
(http://www.hp.com/support).
Mixed processor speeds detected. Please make sure that all processors are the same
speed. — System Halted!
Audible Beeps: 1 long, 1 short
Description: Mixed processor speeds are not supported.
Action: Refer to the server documentation for supported processors. Be sure that all installed processors are
the same speed.

Network Server Mode Active and No Keyboard Attached

Audible Beeps: None
Possible Cause: A keyboard is not connected. An error has not occurred, but a message is displayed to
indicate the keyboard status.
Action: No action is required.
NMI - Button Pressed!
Audible Beeps: None
Possible Cause: The NMI button was pressed, initiating a memory dump for crash dump analysis.
Action: Reboot the server.
NMI - Undetermined Source
Audible Beeps: None
Possible Cause: An NMI event has occurred.
Action: Reboot the server.
Before installing any processors, be sure to follow the guidelines provided in
Error messages 121