Using The Navigator Cd-Rom On The Netserver - Server Mode - HP NetServer LH 6000 Installation Manual

Chapter 10
For status report, use the four-digit Document ID Number printed on the disk; for
example, 7754.
Figure 10-1. Location of Document Number on Navigator CD
Using the Navigator CD-ROM on the NetServer –
Server Mode
1. Press the power-on button.
2. Press the CD-ROM drive eject button.
3. Place the HP NetServer Navigator CD-ROM in the drive and press the
eject button again to close the drive.
NOTE
Using the low profile CD-ROM drive is slightly different than
full-height units. The disk drawer will spring out only part way
when you push the eject button. You must manually pull the
drawer open and manually close it after inserting a CD-ROM.
4. If the CD-ROM fails to autorun, follow the diagnostic instructions on the
screen.
5. Go to the HP Navigator main menu.
NOTE If this is the first time you are using Navigator, you are
prompted to set the language, time, and date. The Main menu
will appear after the information is entered.
6. If the language needs to be changed, select User Preferences and the
language you want.
You can also change the language of the BIOS, but this is only available
when in the BIOS Setup Utility.
All manuals and user guides at all-guides.com
Document
nnnn
Number
Configuring the HP NetServer
107