Adu Version 8.0 Through 8.28 Error Messages - HP ProLiant DL388 Troubleshooting Manual

Write Memory Error
Description: Data cannot be written to the cache memory. This typically means that a parity error was
detected while writing data to the cache. This can be caused by an incomplete connection between the
cache and the controller. This is not a data loss circumstance.
Action: Power down the system and be sure that the cache board is fully connected to the controller.
Wrong Accelerator
Description: This may mean that the board was replaced in the wrong slot or was placed in a system
previously configured with another board type. Included with this message is a message indicating (1) the
type of adapter sensed by ADU
configured in EISA NVRAM.
Action: Check the diagnosis screen for other error messages. Run the server setup utility to update the system
configuration.

ADU version 8.0 through 8.28 error messages

This section contains a complete alphabetical list of all ADU
messages. ADU is being replaced by the ACU diagnostics feature
following versions are installed on the server, see the messages in this section:
•
ADU version 8.0 through ADU version 8.25
•
ACU diagnostics 8.28 and later
Array Accelerator: The batteries were hot-removed.
Action: Replace the batteries.
Array Accelerator: The cache is disabled because the batteries are low on the
redundant controller.
Action: Replace the batteries if the batteries do not recharge within 36 powered-on hours.
Array Accelerator: The cache for this controller is temporarily disabled since a
snapshot is in progress....
...The controller requires a reboot to enable the cache. Until the reboot occurs, array accelerator operations such as
Expansion, Extension, and Migration are disabled.
Action: Reboot the Controller to enable the cache. Until the reboot occurs, array accelerator operations such
as Expansion, Extension, and Migration are disabled.
Array Accelerator: The cache is disabled because the batteries are low.
Action: Replace the batteries if the batteries do not recharge within 36 powered-on hours.
("Array diagnostic software" on page 77), and (2) the type of adapter last
("Array diagnostic software" on page 77) error
("Diagnostics tasks" on page 71). If the
Error messages 112